ZYXEL WAC6303D-S 802.11ac Wave2 3x3 Smart Antenna Access Point with BLE Beacon (no PSU)

Špičkové bezdrôtové služby a skutočná flexibilita do miest s vysokou prevádzkou

Prístupový bod WAC6303D-S je vybavený inteligentnou anténou, ktorá klientom aj v miestach s vysokou

prevádzkou prináša špičkové bezdrôtové služby.



WAC6303D-S navyše podporuje riešenie NebulaFlexTM Pro, ktoré zahŕňa 1-ročnú licenciu Professional

Pack a umožňuje tri prevádzkové režimy (samostatný, riadený kontrolérom a riadený pomocou cloudu Nebula).



MU-MIMO, nová definícia Wi-Fi

Wave 2 ako druhá generácia štandardu 802.11ac prináša novú technológiu Multi-User MIMO (MU-MIMO).

Jedná sa o dôležitý vývoj v oblasti WiFi, ktorý prístupovému bodu umožňuje komunikovať s viacerými klientami

súčasne a ponúka v prípade modelov 3x3 trikrát vyšší výkon.



Nová generácia technológie Transmit Beamforming pre lepšie siete

Ďalším krokom ku spoľahlivej WiFi v prostredí so silnou prevádzkou je technológia Transmit Beamforming (TxBF),

ktorá zvyšuje celkovú prenosovú rýchlosť v sieti, čo je výhodné nielen pre klientov s technológiou MU-MIMO, ale

aj pre všetky stávajúce zariadenia.



Optimálny bezdrôtový výkon

Model WAC6303D-S je vybavený inteligentnou anténou, ktorá preukázateľne znižuje rušenie v rovnakom kanáli a

svoj výkon operatívne prispôsobuje prostrediu s veľkou prevádzkou.



RF Specifications

802.11n/ac premium features

2.4GHz: 2x2 MIMO with two spatial stream (SU-MIMO)

5GHz: 3x3 MIMO with three spatial stream (SU-, or MU-MIMO)

802.11ac beamforming (transmit beamforming)

Maximal ratio combining (MRC)

Low End Sensitivity Improvements (LESI)

Time Domain Channel Smoothing

20-, 40- and 80-MHz channels

PHY data rates total up to 300 Mbps (11n) + 1300 Mbps (11ac)

Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)

Cyclic Delay diversity (CSD) support

Maximum Likelihood Demodulation (MLD) support

Low Density Parity Check (LDPC) support

Typical transmit output power (dBm) *1

US (FCC) 2.4 GHz: 25 dBm

US (FCC) 5 G GHz: 28 dBm

EU (ETSI) 2.4 GHz: 20 dBm

EU (ETSI) 5 G GHz: 26 dBm

Antenna gain

2.4 GHz: 3 dBi; 2x2 MIMO

5 GHz: 4 dBi 3x3 MIMO

Support data rate

802.11a/g: 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, and 54 Mbps

802.11n: up to 300 Mbps in MCS15 (40MHz; 2 Spatial Streams; GI=400ns)

802.11ac:up to 1300 Mbps in MCS9 (80MHz; 3 Spatial Streams; GI=400ns)

Receive sensitivity Min. Rx sensitivity up to -103 dBm

Interfaces

Number of 10/100/1000M LAN 2 x switch ports

Console port 4-Pin serial

Input power requirements Direct DC power or Power over Ethernet (PoE)*2

PoE 802.3at (full mode)

802.3af (Restrict 2.4G & 5G radio to one transmit stream only.)

PoE power draw 16.2W (802.3at PoE)

WLAN

WLAN maximum throughput Up to 1600 Mbps

Fast roaming Pre-authentication and PMK caching

Wireless Security

WPA/WPA2-PSK

WPA/WPA2-Enterprise

WLAN access control list

EAP type

IEEE 802.1X

MAC filtering

Web authentication *3

Layer-2 isolation

RADIUS authentication

Microsoft AD authentication*3

LDAP authentication *3

MAC authentication *3

Rogue AP detection

Number of SSID 16

QoS

WMM

WMM power save

U-APSD

DiffServ marking

Network

IPv6 support Yes

VLANs Yes

DHCP client Yes

Management

ZON Utility*4

Discovery of Zyxel switches, APs and gateways

Centralized and batch configurations

IP configuration

IP renew

Device factory reset

Device reboot

Device locating

Web GUI access

Firmware upgrade

Password configuration

One-click quick association with Zyxel AP Configurator (ZAC)

Smart Connect

Neighbor device discovery

One-click remote management access to the neighboring Zyxel devices

Zyxel AP Configurator*5

Batch AP configuration

Batch AP firmware upgrade

Batch AP profile backup

Zyxel Wireless Optimizer *6

Wi-Fi AP planning

Wi-Fi coverage detection

Wireless health management

Standalone AP mode Yes

Managed AP mode Yes

CLI Yes

SNMP v2c/v3

Standard Compliance

Ethernet

IEEE 802.3

IEEE 802.3u

IEEE 802.11ab

IEEE 802.3au

IEEE 802.3az

IEEE 802.3af/at

PoE IEEE 802.3af/at

WLAN

802.11b: DBPSK, DQPSK, CCK

802.11g: BPSK, QPSK, 16-QAM, 64-QAM

802.11a: BPSK, QPSK, 16-QAM, 64-QAM

802.11n: BPSK, QPSK, 16-QAM, 64-QAM

802.11ac: BPSK, QPSK, 64-QAM, 256-QAM

Certifications

Radio

FCC Part 15C

FCC Part 15E

ETSI EN 300 328

EN 301 893

LP0002

EN 60601-1-2

EMC

FCC Part 15B

EN 301 489-1

EN 301 489-17

EN55032

EN55024

EN61000-3-2/-3

BSMI CNS13438

Safety

EN 60950-1

IEC 60950-1

BSMI CNS14336-1

Physical Specifications and others

Item Dimensions (WxDxH)(mm/in.)

211 x 223 x 39 / 8.31 x 8.78 x 1.54

Weight (kg/lb.)

800/1.76

Packing Dimensions (WxDxH)(mm/in.)

251 x 247 x 55 / 9.88 x 9.72 x 2.17

Weight (kg/lb.)

1040/ 2.29

Included accessories Wall/ceiling mount plate

Plenum rating Yes

Kensington lock support Yes

Power supply Input: AC 100-240V, 50~60Hz

Output: DC +12V 2A (Sold separately)

MTBF (hr) 3,960,217

Environmental Specifications

Operating Temperature

-20°C to 60°C / -4°F to 140°F

Humidity

10% to 90% (Non-condensing)

Storage Temperature

-40°C to 70°C / -40°F to 158°F

Humidity

10% to 90%

Models

RF Specifications

802.11n/ac premium features

Typical transmit output power (dBm) *1

Antenna gain

Support data rate

Receive sensitivity

Interfaces

Number of 10/100/1000M LAN

Console port

Input power requirements

PoE

PoE power draw

WLAN

WLAN maximum throughput

Fast roaming

Wireless Security

Number of SSID

QoS

Network

IPv6 support

VLANs

DHCP client

Management

ZON Utility*4

Smart Connect

Zyxel AP Configurator*5

Zyxel Wireless Optimizer *6

Standalone AP mode

Managed AP mode

CLI

SNMP

Standard Compliance

Ethernet

PoE

WLAN

Certifications

Radio

EMC

Safety

Physical Specifications and others

Item

Packing

Included accessories

Plenum rating

Kensington lock support

Power supply

MTBF (hr)

Environmental Specifications

Operating

Storage

Notes:

*1. Maximum output power is limited by regional regulatory.

*2. When both power sources are available, DC power takes priority over PoE.

*3. Supports when working with Zyxel NXC controller.

*4. Support from ZON Utility V2.1 or above.

*5. Support from ZAC V1.1.4 or above.

*6. Support from ZWO V1.0.5 or above